S5830 DEAD after flash

-----------------------------------------------------------------------------
To connect GT-S5830 phone you have to perform the following steps:
1. Disconnect USB cable from phone.
2. Go to Menu->Settings->Applications->Development.
3. Turn on "USB Debugging" option.
4. When message is appear press "Yes".
5. Go to dial window.
6. Enter "*#9090#" number.
7. Set "Diag config" to "USB" value.
8. Restart phone.
9. Press "Read Info" in software.
Selected firmware file: S5830JPKP9.oct
Please put the phone into Download Mode and connect USB cable.
To put GT-S5830 into Download Mode, You have to perform the following steps:
1. Reconnect the battery.
2. Press and hold "Volume-" +"Power"+''Home" keys.
Searching for a phone. Please wait...
Found phone on
Firmware write started.
Writing mibib section...
mibib section has been written successfully.
Writing qcsbl section...
qcsbl section has been written successfully.
Writing oemsbl section...
oemsbl section has been written successfully.
Writing arm11boot section...
arm11boot section has been written successfully.
Writing boot.img section...
boot.img section has been written successfully.
Writing recovery.img section...
recovery.img section has been written successfully.
Writing system.rfs section...
system.rfs section has been written successfully.
Writing data.rfs section...
data.rfs section has been written successfully.
Writing csc.rfs section...
csc.rfs section has been written successfully.
Please, restart the phone to apply changes
Firmware writing successfully completed.

reason for flash just for change languages

baterry is full and phone no POWER

This entry passed through the Full-Text RSS service - if this is your content and you're reading it on someone else's site, please read the FAQ at http://ift.tt/jcXqJW.

S5830 DEAD after flash